(9) Differential gears.
Note:
1.When assembling without replacing the pinion gear and ring gear with new ones, provide the
same shimming thickness as that provided before disassembly.
2.Backlash between diff-pinion and diff-side gear should be within as range of 0.1 to 0.2mm
(0.004-0.008 in) and these parts should turn smoothly.
3.When reassembling the used pinion and ring gear, reinstall the same thickness of shims as was
installed before disassembly in each shimming position.
4.Backlash adjustment between the drive pinion and the ring pair(Fig5-65, 66) As the drive pinion
and the ring gear make a pair, be sure not to mate them with other parts from differential tractors.
5.Adjust the shimming to backlash of 0.1-0.25 mm (0.004-0.009 in)
5-46
(Fig5-86)
Refer to Parts catalogue
To Next Page
Loading...
