Unipulse F372A - ＜Expansion＞; Exp. Hold Functions; Double Hold; Screens Appearing When Double Hold Is Selected

101
1 EXP. HOLD FUNCTIONS
101
EXP. HOLD FUNCTIONS
Chapter
1
1-1. Double Hold
Specifically combined two types of hold functions are performed simultaneously in one Hold
Section.
You can select hold modes from 26 modes in the following table.
■Screens appearing when double hold is selected
Double-Hold-specific measurement screens appear.
A Hold Setting menu corresponding to the selected hold mode is displayed.
(Example A: Sample B: Inflection Point)
1 EXP. HOLD FUNCTIONS
Hold A Hold B SECTION
0 OFF None None
1 Sample None None
2 Peak None Section select 1
3 Valley None Section select 1
4 P-P None Section select 2
5 Average None Section select 2
6 Inflection Point None None
7 Relative Maximum None None
8 Relative Minimum None None
9 Relative Difference None None
10 Sample Peak Section select 2
11 Sample Valley Section select 2
12 Sample P-P Section select 2
13 Sample Average Section select 2
14 Sample Inflection Point None
15 Sample Relative Maximum None
16 Sample Relative Minimum None
17 Sample Relative Difference None
18 Peak Valley Section select 2
19 Peak P-P Section select 2
20 Valley P-P Section select 2
21 Average Peak Section select 2
22 Average Valley Section select 2
23 Average P-P Section select 2
24 Relative Maximum Relative Minimum None
25 Relative Maximum Relative Difference None
26 Relative Minimum Relative Difference None
Section select 1
All
EXT
EXT+TM
LVL+TM
Section select 2
All
EXT
EXT+TM
LVL+TM
LVL
Hold A
Hold B
Hold A
Hold B
Holding A and B
Each numerical
value and the hold
point are displayed.