20
2 INSTALLATION & CONNECTION
20
INSTALLATION & CONNECTION
Chapter
2
2-1. Installation
To install the F372A into a control panel, use the following procedure.
1. Make a hole in the panel according
to the panel-cut dimensions.
2. Remove the screws (two), and
remove the guide rails from both
sides.
* Do not use other screws than
those installed to the F372A body.
3. Fit in the F372A from the front of
the panel.
4. Install from the rear the guide rails
having been removed from both
sides in Step 2, and fix them with
the screws (two).
2 INSTALLATION & CONNECTION
92mm
Panel-cut
+1
0
–
Panel thickness
1.6 to 3.2mm
dimensions
92mm
+1
0
–
To Next Page
Loading...
