Unipulse F372A - Double Hold Setting; Hold Operations

102
1 EXP. HOLD FUNCTIONS
102
EXP. HOLD FUNCTIONS
Chapter
1
Also, the Comparison Setting menu is dedicated.
■Double hold setting
ON / OFF Initial value: OFF
How to set
When this setting is ON, you can set Hold A and Hold B in Hold Setting.
■Hold operations
For the operations of the HOLD buttons and HI/LO Limit judgment outputs, see the F372
Operation Manual (Standard).
1. A: Sample hold B: None
An arbitrary point is held when the SECTION signal is ON.
SET. Exp. Hold Set. Page 1
→→
Exp. Setting
→
Sensor Input Value䋨Hold Value B䋩
Hold Value
A
Status Display
Status Display
Status Display
Status Display
SECTION
T/H
H/E
----(B)
Blink ON Blink
HOLD䋭B
OFF
----(A)
HOLD䋨A䋩
OFF
OFF