Unipulse F372A - Screens Appearing When Relative Value Comparison Is Selected

125
2 EXP. COMPARISON FUNCTIONS
125
EXP. COMPARISON FUNCTIONS
Chapter
2
● In the case of Comparison
Standard A where
Hold A: Sample
Hold B: Inflection Point
* The comparison output in the
timing chart shown on the
right-hand side applies to the
case where the Comparison
Timing setting in Comparison
Setting is All Time.
● In the case of Comparison
Standard B where
Hold A: Sample
Hold B: Inflection Point
■Screens appearing when relative value comparison is selected
Relative-value-comparison-specific measurement screens appear.
SECTION
T/H ON
H/E ON
HI-A ON
OK ON
LO-A ON
RL-HI ON
RL-LO OFF
HI-A
LO-A
Hold Section
Relative-HI
Relative-LO
A comparison of
Hold B is made
based on the
Relative hold value B
from Hold A
sample hold point
of Hold A.
SECTION
T/H
H/E
HI-B ON
OK ON
LO-B ON
RL-HI OFF
RL-LO ON
Hold Section
HI-B
LO-B
Relative-HI
Relative-LO
Relative Hold A
from Hold B
A comparison of Hold
A is made based on
the inflection point of
Hold B.
Rel.
Hold A
Hold B
Hold A
Hold A
Hold B