66
5 SETTING OF FUNCTIONS
66
SETTING OF FUNCTIONS
Chapter
5
■X(Time) end point
Set the time to display by one screen.
Setting range: 00.1 - 99.9 sec.
How to set
■Y(Load) start point and Y(Load) end point
Setting range: －99999 - 99999 (where Y start point < Y end point)
How to set
SET. Graph Setting Page 1
→→
Work Setting
→
Simple setting call
Press the [X] button on the graph display to go direct to the X end point entry screen.
SET. Graph Setting Page 1
→→
Work Setting
→
Simple setting call
Press the [Y] button on the graph display to go direct to the Y end point entry screen.
CAUTION
About the case to switch work and to draw
When beginning to draw, X (Time) end point and Graph mode, etc. are
read. Therefore, please do not do the work switch while drawing when
these settings are different in each work. Please do after drawing ends.
To Next Page
Loading...
