22
2 INSTALLATION & CONNECTION
22
INSTALLATION & CONNECTION
Chapter
2
■Analog input / output terminals connection
How to connect
1. Strip 5mm of the covering of the wire to be
connected.The size of connectable wires is
from 0.21 to 3.31mm
2
(AWG12 to 24).
2. Twist the tip to such an extent that it will not
spread out.
3. Loosen the screw with a screwdriver to open
the connection hole.
A Phillips screwdriver 3 to 3.5mm #1 in shaft
diameter is recommended.
(Precision screwdriver, etc.)
4. Insert the wire into the connection hole so as
not to let the tip spread out.
5. Tighten the screw with the screwdriver.
0.5Nm of tightening torque is recommended.
6. Lightly pull the wire to make sure that it is securely clamped.
7. Insert the wire-connected plug into the
F372A body, and tighten the screws (two).
How to remove the terminal block
1. Loosen the screws (two) with a screwdriver.
2. Remove the terminal block by giving it
a strong pull.
Adaptable plug ETB42-07P (attachment)
Tighten.
(Turn clockwise.)
Pin No. 1
We sell it as CN80 (optional).
Pin No. 7
(Turn counterclockwise.)
Loosen.
Pin No. 7
Pin No. 1
Tighten.
(Turn clockwise.)
Tighten.
(Turn clockwise.)
Loosen.
(Turn
counterclockwise.
.)
Loosen.
(Turn
counterclockwise.
.)
When installing the terminal block to the F372A body,
check its orientation. (See the illustration at the right.)
Attention
Insert side
Right side
To Next Page
Loading...
