Unipulse F372A - RS-232 C Interface Setting; Communication Mode

70
5 SETTING OF FUNCTIONS
70
SETTING OF FUNCTIONS
Chapter
5
■RS-232C interface setting
Set the RS-232C communication conditions of the F372A.
Communication mode
Normal, Continue, Print
How to set
Baudrate
9600, 19200, 38400, 57600bps
How to set
Data bit
7bit, 8bit
How to set
Stop bit
1bit, 2bit
How to set
Parity bit
NONE, ODD, EVEN
How to set
Delimiter
CR, CR＋LF
How to set
Flow control
Off, RTS/CTS
How to set
■Communication mode
1.Normal
Communications are carried out by commands from the host computer.
The indicated value, status and parameters can be read, and parameters can be written.
2.Continue
The indicated value and status are continuously transmitted.
3.Print
The indicated value is transmitted upon printing (when a print command is output to the SI/F).
SET. RS-232C Setting Page 1
→→
System Setting
→
SET. RS-232C Setting Page 1
→→
System Setting
→
SET. RS-232C Setting Page 1
→→
System Setting
→
SET. RS-232C Setting Page 1
→→
System Setting
→
SET. RS-232C Setting Page 1
→→
System Setting
→
SET. RS-232C Setting Page 2
→→
System Setting
→
SET. RS-232C Setting Page 2
→→
System Setting
→