Unipulse F372A - 7 OPTION INTERFACES; 7-1. BCO Option

141
7 OPTION INTERFACES
141
OPTION INTERFACES
Chapter
7
7-1. BCO Option
You can set data to be output as fixed, or read data by setting external selection.
Connector pin assignments for BCD output
FCN-365P032-AU/FCN-360C032-B
■BCD output data list
*1 BCD data select input condition when the BCD Output Select is External.
*2 Value selected by Comparison Standard in Comparison Setting of the measurement work
no. specified by external input.
No. Signal No. Signal
A1
＊
COM B1
＊
COM
A2 OUT 1 B2 OUT 1000
A3 OUT 2 B3 OUT 2000
A4 OUT 4 B4 OUT 4000
A5 OUT 8 B5 OUT 8000
A6 OUT 10 B6 OUT 10000
A7 OUT 20 B7 OUT 20000
A8 OUT 40 B8 OUT 40000
A9 OUT 80 B9 OUT 80000
A10 OUT 100 B10 OUT Minus (Polarity)
A11 OUT 200 B11 OUT OVER
A12 OUT 400 B12 OUT STAB
A13 OUT 800 B13 OUT STROBE
A14 IN BCD Data Hold B14 IN Logic Select
A15 IN BCD Data Select 0 B15 IN BCD Data Select 1
A16
－
B16
－
BCD data select 1
*1
BCD data select 0
*1
Standard Before Value Double Hold
OFF OFF Real Time value Real Time value Real Time value
OFF ON Hold value Hold value Hold value
ON OFF Real Time value Difference Value Hold value
ON ON Real Time value Real Time value Real Time value
BCD data select 1
*1
BCD data select 0
*1
Double Hold &
Before Value
Comparison
Double Hold &
Relative Value
Comparison
Double Hold &
Before Value
Comparison &
Relative Value
Comparison
OFF OFF Real Time value Real Time value Real Time value
OFF ON Hold value A
Hold value (A/B)
*2
Hold value (A/B)
*2
ON OFF Hold value B Relative value Relative value
ON ON Difference Value Real Time value Difference Value
7 OPTION INTERFACES