Unipulse F372A - 5-10. Comparison Functions

43
5 SETTING OF FUNCTIONS
43
SETTING OF FUNCTIONS
Chapter
5
Setting range: 00 - 99 minutes (with both time)
How to set
5-7. Display Language Selection
The display language of the F372A is selectable between Japanese and English.
Setting range: JPN(日): Japanese, ENG(英): English
How to set
5-8. SI/F Print Out
- OFF
Real time values and hold values are output in the GROSS area and NET area, respectively.
- MD
By this function, the indicated value is automatically printed to the UNIPULSE printer coupled
with the F372A through the SI/F when the indicated value is stable. (Set the stable parameters by
the Motion Detect.)
When Near Zero is OFF, Indicated value is held until Near Zero turns ON after stable turned ON.
(Hold will be released when 1.5 sec. is passed after Near Zero is ON.) The output format is the
same as in the setting of "OFF".
SET. Operation Page 1
→→
System Setting
→
SET. Operation Page 1
→→
System Setting
→
SI/F print out (setting to MD) is not performed under the following conditions.
- Motion Detect Time: 0.0 sec., Count: 0.0 of divisions is set.
Also, the indicated value is not held under the following conditions.
- Hold Mode When any items except Tracking is selected.
Indicated Value
Near Zero
0
Stable
Near Zero
ON
ON
ONON
OFF
OFF
OFF
Autmatic Printing
↑
Hold
1.5Seconds
Time
ON
Hold function……
Indicatid Value
SI/F
Compariosn
＋
Sensor input value
Near Zero
0
Time
Stable
Near Zero
ON
ON
ONON
OFF
OFF
OFF
Autmatic Printing
↑
Hold
1.5Seconds
ON
－
Indicated
Sensor input value
Output signal
Value