91
8 SUPPLEMENTS
91
SUPPLEMENTS
Chapter
8
⑥COM check
The data displayed under "Transmit data" is sent by pressing the
button.
Under "Receive data", externally transmitted data is displayed.
How to set
Please transmit something information sentence from connected equipment side to the check on the
reception. The data received to "Receive data" is displayed. Please confirm the cable or the setting of
communication condition when it is not correctly displayed, when "Parity" or "Frame" lights in red.
Please press button to the check on the transmission. The data displayed in "Transmit
data" is transmitted. It will be confirmed to receive it correctly on connected equipment side. Please
confirm the cable or the setting of communication condition when it is not possible to confirm it.
■Password
This setting is for maintenance and inspection. Do not operate.
8-4. Unit Setting List
* The numbers correspond to the values in the input range of RS-232C.
Also, "0" means no unit.
Mass Force Pressure Others
1 μg12μN25μPa 42 kgm 60 kg/min
2 mg 13 mN 26 mPa 43 gcm 61 t/min
3g 14N 27Pa 44g/cm
3
62 kg/h
4kg 15kN 28hPa 45kg/m
3
63 kg/s
5Mg 16MN 29kPa 46t/m
3
64 t/h
6t 17μNm 30 MPa 47 g/l 65 m
3
/s
7 lb 18 mNm 31 GPa 48 g/ml 66 m
3
/min
8dyne 19Nm 32N/m
2
49 mg/m 67 m
3
/h
9 kdyne 20 kNm 33 μbar 50kg/m 68l/h
10 oz 21 MNm 34 mbar 51 kgm/s 69 l/min
11 TONNE 22 ftlb 35 bar 52 kgm
2
/s 70 l/s
23 inlb 36 mmHg 53 kgm
2
71
％
24 inoz 37 inH
2
O 54mPas 72km
38 ftH
2
O 55 Pas 73 m
39 psia 56 m/s 74 cm
40 psig 57 km/h 75 mm
41 atom 58 m/s
2
76 μm
59 t/s 77 rpm
SET. COM Check
→
Self Check
→
To Next Page
Loading...
