36
4 CALIBRATION
36
CALIBRATION
Chapter
4
4. First select the category, and then
select the unit and determine with
the [OK] button.
Select by scrolling with the
button.
4-6. Zero Calibration
Set the zero point in no-load condition.
How to set
1. Press the [SET.] button.
2. Press the [Calibration] button.
3. Press the [Zero Cal.] button.
4. Press [OK] button after confirming no-
load was applied to the sensor.
* Even if the unit is changed, the display
value (calibration value) will not change.
SET. Calibration Page 1
→→
To Next Page
Loading...
