Unipulse F372A - Setting Procedure; Screens and Operations; Setting Modes Tree

28
3 SETTING PROCEDURE
28
SETTING PROCEDURE
Chapter
3
3-1. Screens And Operations
■Setting modes tree
3 SETTING PROCEDURE
Ordinary display screen
Setting menu screen
PAGE1
HH Limit (P45)
HI Limit (P45)
LO Limit (P45)
LL Limit (P45)
Hysteresis (P45)
PAGE2
Alarm HI Limit (P48)
Alarm LO Limit (P48)
Near Zero (P46)
Comp. Timing (P46)
Comp.Output Sel. (P47)
PAGE1
Graph Mode (P65)
Y(LD) Start Point(P66)
Y(LD) End Point (P66)
X(TM) End Point (P66)
Graph Start Level (P65)
PAGE2
Interval Time (P65)
Level detection conditions (P65 )
PAGE1
Hold Mode (P48)
Hold Start Level (P49)
Section Time (P49)
Level detection Condition (P50)
Operation
Hold Setting
Graph Setting
PAGE2
Motion Detect (P41)
Zero Tracking (P42)
Vol. Out Filter (P67)
Indicate Color (P44)
B5 Func. Select (P67)
PAGE1
Digital Filter (P41)
Analog Filter (P41)
Backlight (P42)
Language (P43)
SI/F Print Out (P43)
PAGE3
B6 OFF Det. Wait (P61)
B8 OFF Det. Wait (P62)
Meas. Work Select (P61)
Contr. Input Sel. (P61)
Password (P91)
PAGE2
Delimiter (P70)
Flow Control (P70)
PAGE1
Com. Mode (P70)
Baudrate (P70)
Data Bit (P70)
Stop Bit (P70)
Parity Bit (P70)
PAGE2
<Sample hold>
Samp.Removal Val. (P50)
<Inflection point hold>
Inf. Minimum Slope (P51)
Inf. F Slope Time (P51)
Inf. R Slope Time (P51)
Inf. Removal Val. (P50)
Det. Start Cond. (P49)
<Relative (Maximum /
Minimum / Difference) hold>
Rel. Minimum Count (P51)
Rel. magnification (P51)
Det. Start Cond. (P49)
<Peak hold or Valley hold,
and Section setting; Level>
Hold Stop Level (P49)
<Average hold>
Ave. Sample Num.(P53)
Work Setting
Comp. Setting
RS-232C Setting
System Setting