49
5 SETTING OF FUNCTIONS
49
SETTING OF FUNCTIONS
Chapter
5
Section time
If you set the hold section setting in the hold function setting to external signal+time or level+time,
set the time.
Setting range: 0.001 - 9.999 sec.
How to set
Hold start level
Set the start level in the case where the Section setting is Level + Time or Level for Peak, Valley, P-
P, or Average hold or where the Detection Start Condition is External + Level for Relative
Maximum, Relative Minimum, Relative Difference, or Inflection Point hold.
Setting range: －99999 - 99999
How to set
Hold stop level
Set the hold stop level in the case where the Section setting is Level for Peak or Valley hold.
Setting range: －99999 - 99999
How to set
Detection start condition
Setting range: Ext+Level, Ext Only
How to set
Simple setting call
Press the [MODE] button at the bottom of the indicated value display screen to go direct to the
hold mode entry screen.
SET. Hold Setting Page 1
→→
Work Setting
→
SET. Hold Setting Page 1
→→
Work Setting
→
To perform hold operation simply by the external section signal (SECTION) without using
the hold start level in the Relative Maximum / Relative Minimum / Relative Difference /
Inflection Point hold mode, change External + Level to External Only in the Detection Start
Condition setting.
SET. Hold Setting Page 2
→→
Work Setting
→
SET. Hold Setting Page 1
→→
Work Setting
→
To Next Page
Loading...
