Unipulse F372A - 2-2. Before Value Comparison in Double Hold

122
2 EXP. COMPARISON FUNCTIONS
122
EXP. COMPARISON FUNCTIONS
Chapter
2
■Before value regulation
* For judging that the difference between the previous and present hold values is too large for
comparison, set the Before Value Regulation. If the absolute value of the difference is larger than
this regulation, the Before Value is not renewed. (Not the present hold value but the previous hold
value is used for the next comparison.)
- Before Value Regulation 0 - 99999 Initial value: 99999
2-2. Before Value Comparison in Double Hold
Before-value-comparison-specific measurement screens in double hold appear.
Also, the Comparison Setting menu is dedicated.
■Comparison standard
In double hold, Before Value Comparison can be made only on either A or B by selecting either
Hold A or Hold B as Comparison Standard.
- Comparison Standard Hold A / Hold B Initial value Hold A
Difference value when the Comparison Standard is Hold A(B) =
Present hold value A(B) - Previous hold value A(B)
A1
－
COM1 COM2
－
B1
A2 OUT DF-HI WORK0 IN B2
A3 OUT HI WORK1 IN B3
A4 OUT OK WORK2 IN B4
A5 OUT LO WORK3(LOCK) IN B5
A6 OUT DF-LO T/H IN B6
A7
－
COM1 COM2
－
B7
A8 OUT HOLD END(H/E) SECTION IN B8
A9 OUT RUN D/Z IN B9
A10 OUT EVENT GRAPH TRIG IN B10
A11 OUT SIF CAL0 IN B11
A12 OUT SIF CAL1 IN B12
FCN-365P024-AU/FCN-360C024-BExternal I/O
Dif.
Hold B
Hold A
Hold B
Hold A
Hold B