Unipulse F372A - 1-3. Auto Reset Selection at the Start of Hold Detection

115
1 EXP. HOLD FUNCTIONS
115
EXP. HOLD FUNCTIONS
Chapter
1
■Sample trigger selection setting
ON / OFF Initial value: OFF
How to set
When this setting is ON, the edge selection setting is displayed in the sample hold setting menu to
allow operation selection.
■Sample trigger select
ON Edge / OFF Edge Initial value: ON Edge
How to set
When the Detection Start Condition is External Only When the Detection Start Condition is External Only
Sensor Input Value Sensor Input Value
Hold Value
A
Hold Value
A
Hold Value B Hold Value B
Status Display
H/E H/E
OFF
Status Display
Status Display
T/H
INF䋨B䋩
OFF
Status Display
Status Display
Status Display
SECTION SECTION
OFF
OFF ON OFF
Blink
OFF
OFF
HOLD䋨A䋩
HOLD䋨B䋩
INF䋨B䋩
T/H
Blink
----(A)
Status Display
HOLD䋨B䋩
OFF ON
HOLD䋨A䋩
Blink
----(A)
OFF OFF
ON
Status Display
Blink
Blink
Blink ON
ONON
● In the case of ON-edge operation
where the hold modes are
A: Sample hold
B: Inflection Point
● In the case of OFF-edge operation
where the hold modes are
A: Sample hold
B: Inflection Point
SET. Exp. Hold Set. Page 1
→→
Exp. Setting
→
SET. Hold Setting Page 1
→→
Work Setting
→