Pg. 23 di 80
How to set Profinet, EtherNet/IP, EtherCAT network address
Profinet
The device has the following factory settings:
Name: txxpnxxxxx
IP Address: 171.16.0.10
IP Mask: 255.255.255.0
Gateway: 0.0.0.0
EtherNet/IP
The device has the following factory settings:
IP Address: 171.16.0.250
IP Mask: 255.255.255.0
Gateway: 0.0.0.0
Bootp: Disabled
DHCP: Disabled
DNS: Disabled
To configure these devices, it is possible to use the master software (i.e. TIA Portal for
Profinet, BootP per Ethernet/IP, TwinCAT per EtherCAT, ecc) or the “Ethernet/IP Device
Configuration” software available on our website (only for Profinet or Ethernet/IP).
Here below an example on how to use the “Ethernet Device Configuration” to set the IP address.
Be sure that in the “Options” “Protocols”, both “NetIdent” and “DCP” are ticked.
To Next Page
Loading...