Pg. 25 di 80
In protocols where it is foreseen, the checkbox “Set Device Name” will be active, and you can set the device name as well.
The procedure is like the one used to install the IP address.
For more details on the use of the program, refer to the program “Help
To be sure that the configured parameters become permanent, remember to remove the tick
from “Store setting temporary” before clicking on “OK”, otherwise the new setting will be
erased at the first device shutdown.
To be able to use the program correctly it is necessary that the PC network card is set on the
same device network. (example 171.16.0.1).
To Next Page
Loading...
Need help?
General