2-4 Valco Cincinnati, Inc.
Section 2 - Safety Information
MC075 - MCP-4 Control Unit
Warning!Warning!
Warning!Warning!
Warning! Do not use a water extinguisher to extinguish the fire!
OTHERWISE, PERSONAL INJURY OR EQUIPMENT
DAMAGE COULD OCCUR.
If the hot melt adhesive ignites, promptly perform the following steps:
1. Sound a fire alarm.
2. Evacuate the immediate area.
3. Turn off all local electrical equipment at the source.
4. Fight the fire in
oneone
oneone
one
of the following ways:
- Smother the fire with a fire blanket.
- Aim a CO
2
fire extinguisher at the base of the flames.
- Aim a dry-powder fire extinguisher at the base of the
flames.
If Adhesive fumes are inhaled, immediately follow these steps:
1. Take the victim away from the immediate work area.
2. Provide victim with fresh air.
3. Call a qualified medical authority.
What to Do if Adhesive-Related
Fire or Explosion Occurs -
Continued
What to Do if
Inhalation of
Adhesive Fumes
Occurs
To Next Page
Loading...
Need help?
General
