This dialog is used to configure the
Display of Service-Message numbers
after a predefined interval (h / km
depending if the Master is defined as
Hourmeter or ODOmeter), to allow
maintenance tasks to be performed in
time. Depending on the Service Codes
there may be different intervals set for
the first notification and the following
intervals. In this example Service-
Message no. 1 is shown after 150 h and
then with a frequency of 150 h again.
Service-Message no. 5 shall be
repeated after all 500 operating hours.
The meaning of the Service-Message
numbers needs to be predefined by the
manufacturer and should be described
in the documentation joining the
vehicle.
June 2009
Training WinGauge Software
page 48
To Next Page
