Need help?Do you have a question about the ViewZ VZ-IP-PVM-N Series and is the answer not in the manual?
Explains manual purpose, audience, and hazard symbols (DANGER, WARNING, CAUTION, NOTICE, NOTE).
Step-by-step guide for logging into and out of the system.
Describes the main interface elements and their functions.
Instructions on how to change the login password for enhanced security.
How to view live video and adjust sensor parameters.
Details on device ID, MAC address, versions, and channel information.
How to set the device ID and name, noting limitations.
Configuring video and audio parameters for the base stream.
Explains parameters like Stream ID, Name, and Video Encode Type.
Details on H.264, H.265, and audio encoding options.
Configuring video resolution, frame rate, and bit rate types.
Introduction to configuring Region of Interest settings.
Lists key local network parameters like IP, subnet, gateway, DHCP, and DNS.
Detailed settings for IP Protocol, DHCP, IP Address, Subnet Mask, Gateway, DNS, and MTU.
Setting up Control, HTTP, RTSP, and RTMP ports for network access.
Details on setting Time Zone, Daylight Saving Time, and NTP synchronization.
Setting channel name, video system (PAL/NTSC), and refresh frequency.
Settings for time display, device name, custom OSD text, font, and transparency.
Important precautions for camera installation and operation for analysis.
Defines the perimeter function for alarms based on target entry into an area.
Setting alarm interval, target type, and target size for perimeter detection.
How to draw and set the deployment area for perimeter detection.
Defines the single virtual fence for forbidden travel direction alarms.
Configuring alarm interval, target type, and size for virtual fence.
How to draw and set the virtual fence line and its direction.
Defines double virtual fence for alarms when targets cross lines in sequence.
Configuring alarm interval, target type, and max pass time for double fence.
How to draw and set the two virtual fence lines and their directions.
Defines loiter detection for alarms based on shortest loitering time.
Configuring alarm interval, target type, size, and shortest loitering time.
How to draw and set the deployment area for loiter detection.
Defines multiple loiter detection for alarms based on shortest loitering time for multiple targets.
Procedures for restarting the device when parameters are incorrect or settings need effect.
Procedures for restoring the device to its original factory settings.
To Next Page
General
