36 D-302756
Here you determine the number of times the communicator will dial the
Monitoring Station’s number via PSTN.
2.
3.
or
Select between "2 attempts", "4 attempts", "8 attempts", "12
attempts" and "16 attempts".
4.
5.
Here you determine the number of times the communicator will try to
report via a cellular group (GPRS, GSM and SMS) to the Monitoring
Station.
6.
7.
or
Select between "2 attempts", "4 attempts", "8 attempts", "12
attempts" and "16 attempts".
8.
9.
Here you determine the number of times the communicator will try to
report via the PowerLink Broadband Module communication to the
Monitoring Station.
10.
11.
or
Select between "2 attempts", "4 attempts", "8 attempts", "12
attempts" and "16 attempts".
12.
You can now press the button to take you to the "
AUTO TEST
TIME
" menu, or press the button to take you to "
<OK> TO EXIT
".
4.7.3.7 Configuring the Auto Test Report
Continue below from the previous section or repeat steps 1 to 4 of section 4.7.3.1 before continuing with the
following instructions:
1.
or
Here you determine the time at which the telephone line will be tested
and reported to the Monitoring Station.
2.
Enter the auto test time.
3.
4.
AUTO TEST TIME
REPORT EVENTS
test time 12:00P
AUTO TEST TIME
LAN RPRT RETRY
LAN RPRT RETRY
4 attempts
GSM RPRT RETRY
GSM RPRT RETRY
PSTN RPRT RETRY
4 attempts
4 attempts
PSTN RPRT RETRY
To Next Page
Loading...
Need help?
General
