Wacker Neuson RD40 User Manual

Operation
Towing the machine
112
BA RD40_RD45 en 00
32
1
Separating the hydrostatic drive power train
Loosen lock nut [1] at the drive pump [3].
Screw in the locking screw [2] until the screw end flushes with the
lock nut.
a
Frictional connection is interrupted: Machine is ready to be towed.
Reconnecting the hydrostatic transmission
Screw out the locking screw [1] until the stop.
Tighten counternut [2].
a
Frictional connection created: machine is ready to be repaired.
3.26.03 Releasing the spring-operated brake
1
The spring-operated brake may only be disabled when:
■
The engine is defective, or
■
The hydraulic system is defective
In the case of a mounted edge pressing and cutting device
(KAG), the screw [1] is covered by the KAG valve block and is
difficult to access.

Wacker Neuson RD40 Specifications

General

Brand	Wacker Neuson
Model	RD40
Category	Construction Equipment
Language	English