Maintenance
Transmission
BA RD40_RD45 en 00
151
a
Visible air shortage: Obtain the specified air pressure with appropriate
filling devices.
Switch off diesel engine and remove ignition key.
Fasten filling hose to the valve [1] and fill the tyre till it reaches the
specified air pressure ("Technical data", page 171).
4.06.08 Changing the tyres
WARNING
Tipping over the machine!
Serious injuries or death through the machine tipping over sideways
because of a shift in the center of gravity.
■
On one axle, only mount and use tyres that are the same type and
have the same design, profile and diameter.
■
Always adjust the tyre pressures on one axle to the same value.
NOTICE
Increased material wear!
Material damage through increased wear on tyres, running gear and
drive parts as a result of a combination of different tyres on each axle.
■
On one axle, only mount and use tyres that are the same type and
have the same design, profile and diameter.
■
Always adjust the tyre pressures on one axle to the same value.
Preparation
Put machine on a safe surface (even, capable of bearing, horizontal)
and secure against rolling away
Switch off diesel engine and remove ignition key.
Have hoisting gear ready that is appropriate for the weight of the
machine and wheels.
Lift the machine until the wheels leave the ground:
■
Apply a jack with sufficient lifting capacity to the marked lifting
points on the chassis, or
■
Lift the machine only by the marked suspension points using
suitable hoisting gear (crane with round sling/chain).
To Next Page
Loading...
Need help?
General
