Operation
Driving
BA RD40_RD45 en 00
81
If the driver does not react,
a
the machine is braked to a standstill after a total of 3 seconds and
the operating functions are deactivated.
a
The diesel engine continues running.
If the driver sits back down within two seconds of leaving the driver's
seat, no braking procedure is initiated.
If the machine is braked by the safety switch, the machine has to be
brought into the home position before operation can be resumed.
Bring the machine into the home position - drive on after the
delayed braking.
Prerequisites:
■
The machine is at a standstill, after delayed braking.
■
Driver sitting on the seat again.
■
Diesel engine is running.
Move the drive lever to position 0.
a
The operating functions are active again.
3.12.02 Adjusting the engine speed
The switch [1] is used to control the speed of the diesel engine between
idling and the maximum speed.
■
Push the switch down: MIN – idling speed
■
Neutral position: ECO – 2/3 of maximum speed
■
Push the switch up: MAX – maximum speed
The vibration frequency is coupled to the engine speed. The
adjustment of the engine speed will elements in the vibration
frequency (see Technical Data).
To Next Page
Loading...
