Operation
Driving with additive sprinkling system
BA RD40_RD45 en 00
95
3.18 Driving with additive sprinkling system
The additive sprinkling moistens the tyres with a separating compound.
The wetting prevents that bitumen sticks on tyres when laying blacktops.
This is the way to make a neat and even covering.
The frequency of sprinkling depends on the temperature of
the tyres. Cold tyres must be moistened more often than
warm ones. Prior to driving on hot blacktops take care that
the running surfaces of the wheels are clean and sufficiently
moistened.
The emulsion may only be mixed of parting agent concentrate
and water according to the indications of the parting agent
producer (Observe regulations for environment protection).
Switching on and off additive sprinkling
Prerequisites:
■
Machine version as a combination roller
■
Electrical system ON
■
No grit spreader installed as add-on equipment.
Press and hold switch [1] or foot switch [2].
a
Additive sprinkling is active for as long as one of the switches is
pressed
a
When controlled by switch [1]: LED [3] on.
Release switch [1] or foot switch [2].
a
Additive sprinkling stops.
a
LED [3] off.
To Next Page
Loading...
Need help?
General
