Wacker Neuson RD40 User Manual

Auxiliary equipment
ROPS cab
BA RD40_RD45 en 00
199
Checking the fill level of the windscreen washer fluid
1
2
The tank [1] for the windscreen washer fluid is located in the operator's
cab.
Pure water can be used to wash the windscreen. However, we
recommend adding a standard windscreen washer agent (algae growth).
Add an antifreeze solution when outdoor temperatures are below the
freezing point of water. Make sure you use the mixing ratio specified by
the manufacturer.
Fill up windscreen washer fluid in good time.
Open the cover [2] and top up the reservoir [1] with windscreen
washer fluid.
Close the tank by replacing the lid [2].
Replacing the fresh air filter for the driver's cab
1
12
1 1
Change the filters according to the amount of dust
accumulated.
Switch off the diesel engine and remove the ignition key.
Loosen bolts [1] and remove with the cover and filter element [2].
Replace the cover and filter element [2] by a new one.
Install the cover and filter element [2] and tighten the bolts [1].

Wacker Neuson RD40 Specifications

General

Brand	Wacker Neuson
Model	RD40
Category	Construction Equipment
Language	English