Waters SYNAPT G2 - Connecting the Workstation (System Without ACQUITY UPLC; Connecting Ethernet Cables (System with ACQUITY UPLC

Connecting the workstation (system without ACQUITY UPLC) B-21
Connecting the workstation (system without ACQUITY
UPLC)
Requirement: Use a shielded network cable with the mass spectrometer to
ensure compliance with FCC limits.
Before connecting the workstation to the instrument, set up the workstation
according to its accompanying instructions. Locate the workstation within
5 meters (16 feet) of the instrument.
Required materials
Shielded network cable
To connect the workstation
Requirement: Use a shielded network cable with the mass spectrometer to
ensure compliance with FCC limits.
1. Connect the monitor to the PC.
2. Connect one end of the shielded network cable to the port labeled
instrument LAN on the rear panel of the mass spectrometer (see
page B-16).
3. Connect the free end of the shielded network cable to the port labeled
instrument LAN on the workstation rear panel.
Connecting Ethernet cables (system with ACQUITY
UPLC)
Requirement: Use shielded network cables with the mass spectrometer to
ensure compliance with FCC limits.
Required materials
Two shielded network cables
To make Ethernet connections
1. Connect one end of one shielded Ethernet cable to the network switch.