PergoTex II/ PergoTex II LED
Instructions for assembly
We reserve the right to make technical changes
9.3 Programming the Somfy radio
For Somfy without LED option
• Connect construction to the power supply voltage (connect drive with Somfy
Universal RTS).
• Somfy radio control for the drive can be taught.
• Teach travel direction and channel (see separate Somfy Universal RTS instructions
for use).
• If necessary, teach further remote-receivers on the channel.
For Somfy with LED option
• Connect the construction to the power supply voltage and disconnect the Somfy
Lighting RTS light-remote-receiver from the power supply voltage (see in Chapter
Circuit diagrams under Somfy LED **).
• Only the Somfy Universal RTS drive remote-receiver can now be taught.
• Teach travel direction and channel (see separate Somfy drive instructions for use).
• If necessary, teach further remote-receivers on the channel.
• Reconnect the Somfy Lighting RTS light remote-receiver to the power supply voltage.
• Press the channel on which the light should be taught and teach the light.
• Tilt the receiver box on the wall gap sealing profile upwards again (see Chapter
Receiver box with LED lighting).
To Next Page
Loading...
Need help?
General
