PergoTex II/ PergoTex II LED
Instructions for assembly
We reserve the right to make technical changes
5 Wall installation
5.1 Installation of the wall gap sealing profile
Improper selected fixing material
Appropriate dowels and chemical anchoring materials must be selected at the site of installation
after estimation
of the type of masonry there.
During this estimation, a number of factors must be taken into account: condition,
consistency, compactness, surface appearance.
Further information can be found by consulting the notes provided by the
manufacturers of the anchoring systems.
Unevenness and slopes on the on-site circuit points
Any unevenness and slopes on the on-site circuit points must be levelled out on-site. This
is essential to ensure that the weinor PergoTex II is installed correctly.
Possible resources / fixings for levelling out unevenness:
• Support blocks
Figure 3: View of uneven wall from above
To Next Page
Loading...
