PergoTex II/ PergoTex II LED
Instructions for assembly
We reserve the right to make technical changes
2.3 Transportation
The maximum permissible axle loads and gross vehicle weight of the goods vehicles must not
be exceeded. Loading a vehicle can alter its handling characteristics.
The transported goods must be mounted properly and securely. The packaging must be
protected against moisture. Softened packaging can come loose and cause accidents.
Packaging which has been opened for incoming goods inspections must be sealed again
properly for further transport.
When unloaded, the sun protection must be carried to the place of installation the right way
round so it does not have to be turned round again in a confined space. The note on the
packaging about which way up the construction should be placed must be noted.
2.4 Lifting with ropes
If the weinor PergoTex II needs to be raised to a higher level using ropes, the weinor PergoTex II
must be
• removed from the packaging;
• connected to the hauling ropes so that it cannot slide out;
• lifted horizontally and evenly.
The same applies when dismounting the weinor PergoTex II.
2.5 Fixing material
The weinor PergoTex II complies with the requirements of the wind resistance class shown on
the CE-conformity mark. When fitted, it only complies with these requirements provided that
the weinor PergoTex II is installed in the manner recommended by the manufacturer, and
the weinor PergoTex II is installed using the dowel extraction forces recommended by the
manufacturer, and the manufacturer’s guidelines on dowels are observed when performing the
2.6 Ladders
Do not lean ladders against the weinor PergoTex II or mount them to the weinor PergoTex II.
Ladders must be on a firm base and provide adequate support. Only use ladders with adequate
2.7 Anti-fall guards
Workers run the risk of falling when working at elevated heights. Suitable fall protection
equipment must be used.
To Next Page
Loading...
Need help?
General
