PergoTex II/ PergoTex II LED
Instructions for assembly
We reserve the right to make technical changes
2.12 Handover
All operating manuals as well as the manufacturer's assembly and setting instructions for drives,
commutators and controls must be handed to the user who must be instructed in the operation of
the unit. Detailed instruction II on the safe and proper operation of the weinor PergoTex II must
be given. If this is not adhered to and the weinor PergoTex II is operated incorrectly, damage or
accidents could result.
The instructions must be retained by the customer and passed on to the new owner if ownership
of the weinor PergoTex II is passed to a third party.
After noting the structural conditions and completing assembly, the installation firm is to inform
the user whether the wind resistance class specified by the manufacturer was achieved following
assembly. If not, the installation firm must record the wind resistance class actually achieved.
Automatic controls must be set to this level.
The customer must confirm to the fitter in writing that the weinor PergoTex II is the right model
and has been installed correctly, indicating the assembly time, and that final acceptance of the
weinor PergoTex II has taken place during which the safety instructions were discussed (see
2.13 Test run
• When ascending the weinor PergoTex II for the first time, its working range and the area
below it must be kept clear. A visual inspection of the fixing material and brackets must be
performed after the weinor PergoTex II has been ascended for the first time.
• When carrying out test runs, never use automatic system controls or commutators if the
weinor PergoTex II is not in the operator's line of vision (danger of unintentional start-up). We
recommend that you connect a test lead to the motor input.
• With the weinor PergoTex II, it is especially important to set the drive during running-in with
point limiter approx. 2 cm before the end position and during ascending with torque limiter.
The installation and adjustment instructions supplied by the manufacturer of the drive,
commutators and controls must be observed.
To Next Page
Loading...
Need help?
General
