WinGD X72-B - Page 277

Tab 6-21 FUEL / LUBRICATION SYSTEM
Item Function Effect
002 Cylinder Lubrication Oil Type indi-
cation
Shows the type of cylinder lubrication oil in use
Shows: Low BN, High BN
003 Cylinder Lubrication Mode indica-
tion
Shows the status of the cylinder lubrication
Shows: Dry Running, Pre-Lubrication, Speed Dependent, Load
Dependent, Manual Lubrication, Stopped
004 Used Fuel Type indication Shows the fuel in use
Shows: HFO, LFO, GAS, LFO & GAS, HFO & GAS
005 LOW BN button Changes to low BN cylinder oil
006 LFO button Changes to LFO (Light Fuel Oil)
007 HIGH BN button Changes to high BN cylinder oil
008 HFO button Changes to HFO (Heavy Fuel Oil)
009 AUX SO PUMP START/STOP Starts and stops the auxiliary electric servo oil pump (servo oil
service pump)
NOTE: If necessary, start this pump only in engine stop mode.
010 MANUAL LUBRICATION button Starts the manual cylinder lubrication procedure related to the
set values
011 Manual Lubrication Cylinder but-
tons
Manually select the cylinder for manual lubrication:
•
Set 1 to n for the related cylinder
•
Set 0 (zero) for all cylinders
012 Manual Lubrication Pulses buttons Manually set the number of injections for lubrication at engine
stop mode (range 0 to 255)
X72-B
AA00-4618-08AAA-043B-A
Operation Manual MCP page - FUEL / LUBRICATION SYSTEM
Winterthur Gas & Diesel Ltd.
- 277 - Issue 003 2021-12