WARNING
Injury hazard. Before you operate the turning gear, make sure that no personnel are near
the flywheel, or in the engine.
16 Operate the turning gear to move the crankshaft in the applicable direction.
NOTE: While the gear wheel turns, the carrier (008) moves the thrust pads. The first
thrust pad (007) will come out.
17 Keep a light tension on the manual ratchet (011) and the chain block (005) while the
thrust pad (007) moves up.
18 Remove the thrust pad (007).
19 Remove carefully the manual ratchet (010).
20 Use the chain block (005) and the manual ratchet (011) to move the thrust pad (007) to
the exhaust side.
21 Lower the thrust pad (007) on to a stable area.
22 Do Step 15 to Step 21 for the remaining thrust pads you must remove.
X72DF
AA00-1203-00AAA-520A-A
Maintenance Manual Thrust bearing - remove the pads
Winterthur Gas & Diesel Ltd.
- 142 - Issue 002 2020-10
To Next Page
Loading...
Need help?
General
