PROCEDURE
1 Open the relief valve with the spindle (001, Figure 7-55).
2 Disconnect the electrical cable from the connector.
3 Remove the two screws (002).
4 Remove the relief valve from the cylinder cover (003).
5 Remove and discard the O-rings.
Fig 7-55 Relief valve combustion chamber
6 If necessary remove the sensor (004).
6.1 Remove the holder (005) and the sensor (004) from the tip of the relief valve.
6.2 Remove the holder (005) from the sensor (004).
6.3 Remove the sensor (004) with the cable from the relief valve.
CLOSE UP
• None
X72DF
AA00-2740-00AAA-520A-A
Maintenance Manual Relief valve combustion chamber - remove
Winterthur Gas & Diesel Ltd.
- 289 - Issue 002 2020-10
To Next Page
Loading...
