PROCEDURE
1 Install the first servo oil pump.
1.1 Put a new O-ring in the pump support.
1.2 Apply a small quantity of oil to the O-ring.
1.3 Put the sling around the servo oil pump two times.
1.4 Attach the sling to the engine room crane.
1.5 Operate the engine room crane to put the servo oil pump in position.
1.6 Attach the servo oil pump to the casing with the nuts and the washers.
1.7 Remove the sling from the servo oil pump.
2 Do Step 1 again to install the other servo oil pump(s).
3 Finish the installation of the servo oil pumps.
3.1 Install all pipes to the servo oil pumps.
3.2 Connect the electrical connections.
3.3 Install the applicable HP fuel pipes from the related fuel pumps.
CLOSE UP
• None
X72DF
AA00-5551-00AAA-720A-A
Maintenance Manual Servo oil pump - install
Winterthur Gas & Diesel Ltd.
- 538 - Issue 002 2020-10
To Next Page
Loading...
Need help?
General
