WORKSWELL WIRIS PRO - Reset to Factory Default; Remote Control; System Update

21. TROUBLESHOOTING
21.4 Reset to Factory Default
You can reset the WIRIS Pro to its factory default state with the pin buon. Press the pin buon for more then
5 seconds. The LED should start blinking rapidly. Do not unplug the WIRIS Pro from power source during this
process!
Factory default can help in some situaons. Typically if some sengs or update caused the WIRIS Pro to stop
displaying the image or other minor things like going back to previous working rmware version.
Factory default will not work if the LED is not eming light.
21.5 Remote Control
When selecng the TRIGGER mode for a digital input, make sure that the selected input is not connected to your
remote controller with PWM output. Otherwise, the TRIGGER input will not behave as expected.
21.6 System Update
Make sure that your WIRIS Pro version is up to date. You can nd informaon about the current version on
hps://www.workswell‐thermal‐camera.com/rmware‐update/
E‐mail and Web
info@workswell.eu
www.workswell.eu
Mobile:
+420 725 877 063
ID:
Reg. No.: 29048575
VAT No.: CZ29048575
Headquarters
U Albrechtova vrchu 12
155 00, Prague 13
Czech Republic
Version: 201215 EN, 15
th
Dec, 2020
All pictures are only for illustraon.
Real values may vary.
72