wsm L3301 - Page 108

GENERAL
L3301, L3901, L4701, WSM
G-84
Crankshaft Bearing 1 Replacing Tool
Application
• To press out and press fit the crankshaft bearing 1.
[1] Extracting tool
[2] Inserting tool
9Y1211012GEG0015US0
A 135 mm (5.31 in.)
B 72 mm (2.8 in.)
C 40 mm radius (1.6 in. radius)
D 10 mm (0.39 in.)
E 20 mm (0.79 in.)
F 20 mm dia. (0.79 in. dia.)
G 64.80 to 64.90 mm dia. (2.552 to 2.555 in. dia.)
H 59.80 to 59.90 mm dia. (2.355 to 2.358 in. dia.)
A 130 mm (5.12 in.)
B 72 mm (2.8 in.)
C 40 mm radius (1.6 in. radius)
D 9 mm (0.4 in.)
E 4 mm (0.2 in.)
F 20 mm (0.79 in.)
G 20 mm dia. (0.79 in. dia.)
H 68 mm dia. (2.7 in. dia.)
I 59.80 to 59.90 mm dia. (2.355 to 2.358 in. dia.)
J 64.80 to 64.90 mm dia. (2.552 to 2.555 in. dia.)
KiSC issued 09, 2016 A