EasyManua.ls Logo

wsm L3301 - 1 Troubleshooting

wsm L3301
662 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
FRONT AXLE
L3301, L3901, L4701, WSM
6-S1
1. TROUBLESHOOTING
9Y1211012FAS0001US0
Symptom Probable Cause Solution
Reference
Page
Front Wheels Wander
to Right or Left
Tire pressure uneven Adjust G-99
Improper toe-in adjustment (improper alignment) Adjust 6-S6
Clearance between front axle middle boss and
front axle shaft bracket bushing excessive [2WD]
Replace 6-S26
Clearance between front axle case boss and
front axle bracket (front, rear) bushing excessive
[4WD]
Replace 6-S32
Knuckle shaft bushings worn [2WD] Replace 6-S27
Front axle rocking force too small Adjust 6-S7, 6-S7
Front wheel sway excessive Replace 6-S7
Tie-rod end loose Tighten 6-S10,
6-S19,
6-S21
Air sucked in power steering circuit Bleed 7-S10
Front Wheels Can
Not Be Driven
[4WD]
Propeller shaft broken Replace 6-S9,
6-S17
Front wheel drive gears in transmission broken Replace 3-S36,
3-S43,
3-S71
Front differential gear broken Replace 6-S16,
6-S24
Shift fork broken Replace 3-S36,
3-S43,
3-S71
Coupling displaced Reassemble 6-S9,
6-S17
Noise [4WD] Gear backlash excessive Adjust or replace 6-S29,
6-S30,
6-S30,
6-S31
Oil insufficient Fill G-40, G-67
Bearings damaged or broken Replace
Gears damaged or broken Replace
Spiral bevel pinion shaft turn force improper Adjust 6-S29
KiSC issued 09, 2016 A

Table of Contents