wsm L3301 - Page 204

ENGINE
L3301, L3901, L4701, WSM
1-S41
Camshaft Position Sensor
1. Remove the camshaft position sensor mounting screw.
2. Remove the camshaft position sensor (1).
(When reassembling)
• Replace the O-ring with a new one.
IMPORTANT
• If you drop the sensor, do not reuse it.
9Y1211012ENS0036US0
Crankshaft Position Sensor
1. Remove the crankshaft position sensor mounting screw.
2. Remove the crankshaft position sensor (1).
(When reassembling)
• Replace the O-ring with a new one.
IMPORTANT
• If you drop the sensor, do not reuse it.
9Y1211012ENS0037US0
Air Gap Factory specification
0.2 to 1.3 mm
0.008 to 0.059 in.
Tightening torque
Camshaft position sensor
mounting screw
4 to 5 N·m
0.4 to 0.6 kgf·m
3 to 4 lbf·ft
(1) Camshaft Position Sensor
(2) Fuel Camshaft
(3) Sensor
(4) Air Gap
(5) Pulse Cam
(6) Supply Pump Gear
Air Gap Factory specification
0.3 to 1.5 mm
0.002 to 0.059 in.
Tightening torque
Crankshaft position sensor
mounting screw
4 to 6 N·m
0.4 to 0.6 kgf·m
3 to 4 lbf·ft
(1) Crankshaft Position Sensor (2) Air Gap
KiSC issued 09, 2016 A