wsm L3301 - Page 345

TRANSMISSION
L3301, L3901, L4701, WSM
3-S33
[B] Separating Clutch Housing Case
Outer Components
1. Disconnect the throttle cable (15).
2. Remove the steering support (5).
3. Remove the grips (1), (2), and (14).
4. Remove the lever guides (3) and (13).
5. Remove the floor sheet cover (12).
6. Remove the steps (6).
7. Remove the suction pipe 1 (8).
8. Remove the oil filter base (9) with the filter and suction pipe 2
(10).
9. Remove the delivery pipe (7).
10. Remove the brake rods (11) and (18).
11. Remove the shuttle rod (17).
12. Disconnect the PTO safety switch connector (16).
(When reassembling)
• Apply grease to the O-rings and be careful not to damage it.
9Y1211012TRS0023US0
Separating Clutch Housing from Transmission Case
1. Check the clutch housing case and transmission case are
securely mounted on the disassembling stands.
2. Remove the clutch housing mounting screws.
3. Separate the clutch housing from the transmission case.
(When reassembling)
• Apply liquid gasket (Three Bond 1206C or equivalent) to joint
face of clutch housing case and mid case.
9Y1211012TRS0024US0
Tightening torque
Delivery pipe mounting joint
bolt
49 to 69 N·m
5.0 to 7.0 kgf·m
37 to 50 lbf·ft
(1) Range Gear Shift Lever Grip
(2) Synchro-shuttle Shift Lever Grip
(3) Lever Guide
(4) Front Wheel Drive Lever Grip
(5) Steering Support
(6) Step
(7) Delivery Pipe
(8) Suction Pipe 1
(9) Oil Filter Base
(10) Suction Pipe 2
(11) Brake Rod
(12) Floor Sheet Cover
(13) Lever Guide
(14) Position Control Lever Grip
(15) Throttle Cable
(16) PTO Safety Switch Connector
(17) Shuttle Rod
(18) Brake Rod
Tightening torque
Clutch housing and
transmission case
mounting nut
103 to 117 N·m
10.5 to 12.0 kgf·m
76.0 to 86.7 lbf·ft
KiSC issued 09, 2016 A