TRANSMISSION
L3301, L3901, L4701, WSM
3-S44
PTO Shaft
1. Remove the internal snap ring (1).
2. Tap out the PTO shaft (3) to the front "A".
(When reassembling)
• In the staking nut (2) was removed, replace a new one, and after
tightening it to the specified torque, be sure to stake it firmly.
• Install the slinger (6) firmly.
• After applying liquid gasket (Three Bond 1141 or equivalent) to
joint face of the collar (5), and insert the collar to PTO shaft.
• Apply grease to oil seal (4) and install it, noting its direction.
9Y1211012TRS0043US0
Differential Gear Assembly
1. Remove the differential bearing case (1) mounting screws.
2. Remove the differential bearing case (1), noting the number of
left and right shims.
3. Remove the differential gear assembly (2) from transmission
case.
(When reassembling)
• Use same number of shim as before disassembling.
• Replace the left and right bearing cases on the same sides as
before.
• Apply grease to ball and ball seats.
9Y1211012TRS0044US0
Tightening torque PTO shaft staking nut
147 to 196 N·m
15.0 to 20.0 kgf·m
109 to 144 lbf·ft
(1) Internal Snap Ring
(2) Staking Nut
(3) PTO Shaft
(4) Oil Seal
(5) Collar
(6) Slinger
(7) Oil Seal Cover
(8) O-ring
Tightening torque
Differential bearing case
mounting screw
48 to 55 N·m
4.9 to 5.7 kgf·m
36 to 41 lbf·ft
(1) Differential Bearing Case (2) Differential Gear Assembly
To Next Page
