wsm L3301 - Page 379

TRANSMISSION
L3301, L3901, L4701, WSM
3-S67
[B] Separating Clutch Housing and Mid Case
Outer Components
1. Remove the mounting bolts and the steering support (1).
2. Disconnect the differential lock pedal.
3. Remove the step (2) and the main wiring harness.
9Y1211012TRS0074US0
Suction Pipe and Hydraulic Block
1. Remove the suction pipe (5).
2. Remove the hydraulic block (3).
3. Remove 3P delivery pipe (1).
4. Remove the brake connecting rod R.H. (4) and L.H..
(When reassembling)
• Apply grease to the O-rings.
9Y1211012TRS0075US0
Separating Clutch Housing Case from Mid Case
1. Loosen and remove the screws and the nuts securing the clutch
housing case (1) to mid case (2).
2. Separate the clutch housing case (1) from the mid case (2).
(When reassembling)
• Replace the gasket with a new one.
9Y1211012TRS0076US0
(1) Steering Support (2) Step
Tightening torque
3P delivery pipe joint bolt
49.0 to 69.0 N·m
5.0 to 7.0 kgf·m
36.2 to 50.6 lbf·ft
3P delivery pipe mounting
M8 bolt
23.5 to 24.7 N·m
2.4 to 2.8 kgf·m
18 to 20 lbf·ft
(1) 3P Delivery Pipe
(2) Oil Filter
(3) Hydraulic Block
(4) Brake Connecting Rod (R.H.)
(5) Suction Pipe
Tightening torque
Clutch housing case and
mid case mounting screw
and nut
102.9 to 117.6 N·m
10.5 to 12.0 kgf·m
75.9 to 86.8 lbf·ft
(1) Clutch Housing Case (2) Mid Case
KiSC issued 09, 2016 A