wsm L3301 - Page 51

GENERAL
L3301, L3901, L4701, WSM
G-27
Checking Engine Start System
CAUTION
• Do not allow anyone near the tractor while testing.
• If the tractor does not pass the test, do not operate the
tractor.
 Preparation before testing
1. Place all control levers in the "NEUTRAL" position.
2. Set the parking brake and stop the engine.
[Manual Transmission Type]
 Test: Switch for the shuttle shift lever.
1. Sit on the operator's seat.
2. Shift the shuttle shift lever to the forward or reverse position.
3. Depress the clutch pedal fully.
4. Disengage the PTO gear shift lever.
5. Turn the key to "START" position.
6. The engine must not crank.
 Test: Switch for the PTO gear shift lever.
1. Sit on the operator's seat.
2. Engage the PTO gear shift lever.
3. Depress the clutch pedal fully.
4. Shift the shuttle shift lever to the neutral position.
5. Turn the key to "START" position.
6. The engine must not crank.
[HST Type]
 Test: Switch for the speed control pedal.
1. Sit on the operator's seat.
2. Depress the speed control pedal to the desired direction.
3. Depress the clutch pedal fully.
4. Disengage the PTO gear shift lever.
5. Turn the key to "START" position.
6. The engine must not crank.
 Test: Switch for the PTO gear shift lever.
1. Sit on the operator's seat.
2. Engage the PTO gear shift lever.
3. Depress the clutch pedal fully.
4. Place the speed control pedal in neutral position.
5. Turn the key to "START" position.
6. The engine must not crank.
9Y1211012GEG0074US0
(1) Clutch Pedal
(2) Shuttle Shift Lever
(3) PTO Gear Shift Lever
(4) Speed Control Pedal
[A] Manual Transmission Type
[B] HST Type
KiSC issued 09, 2016 A