Xerox 4112 - Page 225

Setups
Xerox 4112/4127 Copier/Printer 9-67
System Administration Guide
6. Enter the measurement value you obtained in Step 5 in Values A & B Before Adjustment,
and the final value you want after adjustment in Desired Values A & B.
Tip
Set value A and value B so that an edge of the paper does not extend past a fold position of the
paper. An edge of paper extending past a fold position of the paper may cause a paper jam.
7. Press Sample Printout again to print an output sample, and check the adjustment results.
8. Make adjustments again if necessary. (Step 6)
9. Press Save.
Z Fold Position Adjustment
Adjust the Z fold position.
1. Select Z Fold-A4 or Z Fold-8.5x11”, and press Change Settings.
Downloaded From ManualsPrinter.com Manuals