User Guide 1-9
Product OverviewXerox 700 Digital Color Press
Optional finishing accessory Where to find information
Light Production C Finisher (shown here with the required Interface Module, the
optional Booklet Maker and the optional Folder Module)
Information on the Light
Production C Finisher can be found
in this user guide. Refer to the
table of contents for specific page
locations.
The required Interface Module
information is found in the
Accessories chapter of this user
guide.
Note
This finisher provides a wide range of finishing/folding options:
The Light Production C Finisher requires the Interface Module.
Note
The Interface Module (IM) acts as a communication device and paper
path between the printer and the Light Production C Finisher.
1
3
4
2
5
6
2.
3.
4.
5.
6.
Tray 8 (Post-Process Inserter) is standard on this finisher and is used to
load paper that will be used as separators and covers. Tray 8 holds a
maximum of 200 sheets.
The Top Tray is used for stacked output, and can receive up to 500 sheets
of 20 lb./80 gsm paper.
The Stacker Tray is used for offset and/or stapled output, and can hold up
to 3000 sheets of 20 lb./80 gsm paper.
Both the Top and Stacker Trays can be used for hole punched output
(optional).
The Bottom Tray is the Optional Booklet Maker Tray and is used for
receiving saddle-stapled booklets.
The optional Folder is used for C-folding and Z-folding of 8.5 x 11 in./A4
output and 11 x 17 in./A3 media.
1.
Downloaded From ManualsPrinter.com Manuals
To Next Page
Loading...
Need help?
General
