10-11User Guide
AddendumXerox 700 Digital Color Press
If a jam occurs, the machine stops printing and a message is displayed on the User Interface (UI). Follow all
instructions displayed completely and in the sequence shown.
Jam clearance
HCS Entrance Jams (E1, E2, and E3)
Perform the following steps to clear the HCS Entrance jam and resume printing.
HCS Transport Jams (E4, E5, and E6)
Perform the following steps to clear the HCS Transport jam and resume printing.
Open the HCS Front Cover.
Follow the instructions located inside the Front Cover to
clear the E1, E2, or E3 jam.
Lift the green handle and/or rotate the green knob and
remove all paper in the entrance area.
Close the green handle.
Close the HCS Front Cover.
If the UI indicates there is a jam in the digital press,
follow the instructions on the screen to remove any paper
in the area indicates. Refer to the Jam Clearance section
in the Problem Solving chapter in this manual.
Follow the instructions displayed on the digital press UI
to resume printing.
Open the HCS Front Cover.
Follow the instructions located inside the Front Cover to
clear the E4, E5, or E6 jam.
Lift the green handle and/or rotate the green knob and
remove all paper in the transport area.
Close the green handle.
Close the HCS Front Cover.
If the UI indicates there is a jam in the digital press,
follow the instructions on the screen to remove any paper
in the area indicates. Refer to the Jam Clearance section
in the Problem Solving chapter in this manual.
Follow the instructions displayed on the digital press UI
to resume printing.
Downloaded From ManualsPrinter.com Manuals
To Next Page
Loading...
