Registering/Deleting/Renaming Stored Programs
219
Stored Programming
7
Registering/Deleting/Renaming Stored Programs
The [Stored Programming] screen allows you to register, delete, and rename stored
programs.
Important • When registering a stored program to select paper size or type loaded on Tray 5 (Bypass),
register both the paper size and the paper type. If only one of them is registered, the stored
program may not be called properly.
• If any of the following operations is performed while a stored program is being registered,
the stored program may not be registered or may not work correctly.
- Removing or inserting a paper tray
- Loading or reloading paper into Tray 5 (Bypass)
• If any of the following operations is performed after a stored program registration, the
registered stored program may not be called properly.
- If the stored program has the Watermark feature and a Watermark setting is changed.
- If any registered feature becomes disabled due to its value change under System Settings.
- If the stored program has an operation for a mailbox and the mailbox passcode is changed.
Note • The following cannot be registered: System Settings, [Browse...] under Scan to PC, Job
Flow Sheets, Address Book, and other stored programs.
• A stored program registration is cancelled when the <Interrupt> button is pressed, when the
Auto Clear feature causes a time-out, or when a popup window (such as a paper jam
window) appears.
1
Press t
he <Al
l Servic
es> bu
tton.
2
Select [Setup Menu].
3
Select [Stored Programming].
4
Select the feature.
îš„Store
Register a stored program.
Refer to "Registering Stored Programs" (P.220).
îš„Delete
Deletes a stored program.
Refer to "Deleting Stored Programs" (P.220).
îš„Enter/Change Name
Enter or change a stored program name.
Refer to "Entering/Changing a Stored Program Name" (P.221).
To Next Page
Loading...
Need help?
General
