Fax Mode Settings
315
System Settings
10
Incoming iFax Print Options
Set the print operation to be enabled when e-mail that is sent to the machine's e-mail address
is received from a machine with the iFax feature.
îš„Attachment
Only prints the attached documents.
îš„Full Headers and Contents
Prints the e-mail header and body of the e-mail.
îš„Basic Headers and Contents
Prints a part of e-mail headers (From/To/Subject/Date) and the body contents.
îš„Auto Print
If [Auto Print] is enabled, prints out only when the e-mail has its contents.
Incoming iFax Output Destination
Set the output tray to be used for printed iFax documents.
Note • This feature does not appear for some models. An optional package is necessary. For more
information, contact our Customer Support Center.
Fax Transfer from Address Book
Set whether to permit forwarding of iFax data that is received by email via SMTP when the
forwarding destination is not registered in Address Book.
îš„Off
Permits forwarding.
îš„On
Checks if the forwarding fax number is listed in the address book, and if not, rejects receiving
the email and deletes it.
Fax Transfer - Add Sender Header
When forwarding received e-mail from iFax to fax, select whether to add a send header (start
time, sender name, recipient name, G3 ID, and number of pages).
Fax Transfer Maximum Data Size
When sending a received e-mail from iFax to fax, set the maximum data size.
îš„No Limit
No limit on data size.
îš„Set Limit
Specify a value within the range from 1 to 65,535 KB, in 1 KB increments. If a data size
exceeds the specified value, the data is discarded.
To Next Page
Loading...
Need help?
General
