Setup Menu
331
System Settings
10
Relay Station Setup
When the machine is used as a relay station in a relay broadcast, select whether or not to
certify the registered address number as an initiating station for the relay broadcast.
When performing the relay broadcast, the initiating station must be registered to an address
number in the relay station regardless of the instruction method.
Communication Mode
Set the communications mode. You can select [G3 (Auto)] or [F4800].
When the destination is specified by an address book entry with the communications mode
set, it is not possible to change the communications mode in the [Fax/iFax] screen.
Note • [G4 Auto] appears when an Internet Fax Kit is installed. For iFax, the setting applies to the
section between the fax gateway and the recipient fax.
Resolution
Set the transmission image quality.
Select from [Panel] (image quality selected on the control panel), [Standard], [Fine],
[Superfine (400 dpi)], and [Superfine (600 dpi)].
Cover Note
Select whether to send transmissions with a cover note attached. If attached, specify
comments relating to the recipients and sender to be included in the cover notes.
Comments must be registered in advance.
For information on comment registration, refer to "Comments" (P.335).
1
Select [Off] or [On].
2
When [On] is selected, select
[Comment].
3
Select [Recipient's Comment].
4
Select [On], and select a comment
from the displayed list of
comments.
Note • Select [ ] to return to the
previous screen or [ ] to
move to the next screen.
5
Select [Save].
6
To insert a sender's comment, select [Sender’s Comment] in step 3, and then repeat
steps 4 and 5.
Maximum Image Size
Select the maximum storage size from [A3], [B4], and [A4], to match the recipient's paper size
or processable profile.
To Next Page
Loading...
Need help?
General
